DIY $1 Halloween Frame & Free Halloween Printable

September 26, 2013 3 Comments | Disclosure

How to turn a One Dollar Frame into a fun, frugal, and easy Halloween decoration:

I needed one more thing for my entryway table so I I picked up some of my favorite $1 frames and got busy creating this:

Dollar Store Frames Craft

{PIN THIS}

It was quick and easy to make {and very inexpensive}. I made 2, one for me and one for a friend. Here is what you need to make your own:

what you need

Supplies:

Square $1 Frames {Wal-Mart or Michaels}

Black Paint

Mod Podge {get it here}

Decorative Halloween Paper {leftover from my banner}

Black or Orange Cardstock

Ribbon {find some here}

Sanding sponge or big emery board

You can download the cute Halloween Printable here. Just print it out on white cardstock.

DSC_5506

First paint the edges of the frame and the inside edges of the frame. I painted the back too.

DSC_5507

After the paint dries brush a layer of mod podge over the front of the frame and place the Halloween paper. Make sure to rub out any bubbles.

DSC_5509

I place it upside down and put something heavy on it while it dries. It doesn’t take  very long to dry.

DSC_5508

This is my favorite way to remove the extra paper: after the mod podge has dried, take a sanding block and rub it along the edges in a downward motion.

DSC_5510

Rub it until it comes right off.

DSC_5511

For the picture part I use an exacto knife to cut an X in the middle

DSC_5512

Then use the large emery board to “sand” off the inside paper.  Make sure you always go downward or you will tear your paper. DSC_5514

DSC_5515

Cut out your prints, I decided that mine needed a little something more so I sponged the edges of the print and the edges of the frame with black ink. I also discovered that I made the prints a tad to small so I cut out some 3 3/4 inch squares of orange and black cardstock and mounted the print on them. I liked how this looked in the frame better anyway.

DSC_5516

Tie some ribbon on using a square knot (right over left, left over right). I used 3 ribbons, odd numbers look better when you are doing things.

DSC_5520

Place your print in the opening. Aren’t the fun! I love how they turned out. It took me less than 30 minutes to make both of them {that includes drying time}.

DSC_5522

Here it is on my entryway table.

DSC_5532

I love how it looks with my other décor.

DSC_5533

1 frames

{PIN THIS}

Comments

  1. Meridian Mama says:

    Very cute! Love how you remove the excess paper, I’ll remember that one for sure!!

  2. So cute and looks easy enough for me too! Thanks for your nice clear directions.

  3. Never would’ve thought of this! Love it! I’ve been wondering what to do with some old frames. I hate throwing things out, and sending them to a thrift store is no good, because I just KNEW I’d eventually figure out what to do with them. ;)

Leave a Comment
Want to see your picture by your comment? Get your custom avatar by registering for free at Gravatar.

*